Vestil ZLTT series Manuale Utente Scaricare il pdf

Rev 02/08 08/04

VESTIL MFG. CO./T&S EQPT. CO. 1 of 16

VESTIL MANUFACTURING CORP.

2999 N. Wayne St., Angola, IN 46703

Ph: 260-665-7586 · Fax: 260-665 -1339

E-mail: [email protected]

· www.vestil.com

MODEL ZLTT GROUND-CLEARANCE LIFT-AND-TILT TABLE

Serial number: _______________

Installation Instructions ……………….....................… 2

Warnings & Safety Instructions .…………….……….. 3

Operation Instructions ................................................... 4

Routine Maintenance & Safety Checks …………....… 5

Exploded Structural Parts Drawing & BOM ……….. 6 - 7

Motor & Transformer Connections ............................... 8

Electric / Hydraulic BOM ............................................. 9

Electrical Diagram ....................................................... 10

Hydraulic Diagram ....................................…….......... 11

Power Unit’s Operation …………………….…….…. 12

Safety Labels ................................................................ 13

Troubleshooting ………………………………….….. 14

Notes ............................................................................ 15

Warranty ……………………...…………………..…. 16

WARNINGS AND SAFETY INSTRUCTIONS

Ensure that all employees understand and follow the following.

o Read and understand the owner’s manual before using or servicing

the lift.

o The load must be removed and the platform fully lowered before

any work is performed on the lift.

o Ensure that all safety and warning labels stay in place and are

legible.

o Do not use the lift if any damage or unusual noise is observed.

o Always watch the platform and the container carefully when the lift

is in operation.

o Do not perform any modifications to the lift without the

manufacturer’s approval. Failure to receive authorization for

changes to the equipment could void the warranty.

o Maintenance and repairs are to be done only by personnel qualified

to perform the required work.

o Do not use brake fluid or jack oils in the hydraulic system. If oil is

needed, use an anti-wear hydraulic oil with a viscosity grade of

150 SUS at 100°F, (ISO 32 cSt @ 40°C), or Dexron transmission fluid.

WHEN ORDERING

REPLACEMENT PARTS:

We take pride in using quality

parts on the equipment we

manufacture. We are not

responsible for equipment

problems resulting from the use

of unapproved replacement

parts.

To order replacement or

spare parts for this equipment,

contact the factory.

In any communication with

the factory please be prepared

to provide the machine’s serial

number, which is indicated on

the machine dataplate.

RECEIVING INSTRUCTIONS

Every unit is thoroughly

tested and inspected prior to

shipment. However, it is

possible that the unit could

incur damage during transit.

Inspect the unit closely when

it arrives. If you see evidence

of damage or rough handling to

either the packaging or to the

product when it is being

unloaded, immediately

make a

note of it on the Bill Of Lading!

It is important that you

remove the product’s packaging

upon its arrival to ensure that

there is no concealed damage

or to enable a timely claim with

the carrier for freight damage.

Also, verify that the product

and its specifications are as

ordered.

WNER

’

MANUAL

1 2 3 4 5 6 ... 15 16

Sommario

Pagina 1 - RECEIVING INSTRUCTIONS

Rev 02/08 08/04 VESTIL MFG. CO./T&S EQPT. CO. 1 of 16 VESTIL MANUFACTURING CORP. 2999 N. Wayne St., Angola, IN 46703 Ph: 260-665-7586 · Fax:

Pagina 2

08/04 VESTIL MFG. CO./T&S EQPT. CO. 10 of 16 ELECTRICAL DIAGRAM -- MODEL ZLTT o Warning: Care should be taken to identify all potential hazard

Pagina 3

08/04 VESTIL MFG. CO./T&S EQPT. CO. 11 of 16 HYDRAULIC DIAGRAM – MODEL ZLTT o Warning: Care should be taken to identify all potential hazards

Pagina 4 - Operation:

08/04 VESTIL MFG. CO./T&S EQPT. CO. 12 of 16 THE POWER UNIT’S OPERATION -- MODEL ZLTT The electric / hydraulic zero-clearance lift-and-tilt ut

Pagina 5

08/04 VESTIL MFG. CO./T&S EQPT. CO. 13 of 16 SAFETY LABEL LOCATIONS -- MODEL ZLTT

Pagina 6

08/04 VESTIL MFG. CO./T&S EQPT. CO. 14 of 16 TROUBLESHOOTING GUIDE -- MODEL ZLTT Before performing any task, always lower the platform fully to

Pagina 7

08/04 VESTIL MFG. CO./T&S EQPT. CO. 15 of 16 NOTES:

Pagina 8 - CAUTION!

08/04 VESTIL MFG. CO./T&S EQPT. CO. 16 of 16 POWERED PRODUCTS’ WARRANTY ONE YEAR LIMITED WARRANTY The manufacturer warrants for the original

Pagina 9

08/04 VESTIL MFG. CO./T&S EQPT. CO. 2 of 16 INSTALLATION INSTRUCTIONS – MODEL ZLTT Review this entire page before installing the lift. Consult

Pagina 10

08/04 VESTIL MFG. CO./T&S EQPT. CO. 3 of 16 WARNINGS AND SAFETY INSTRUCTIONS, MODEL ZLTT Ensure that all employees understand and follow the f

Pagina 11

08/04 VESTIL MFG. CO./T&S EQPT. CO. 4 of 16 OPERATION INSTRUCTIONS – MODEL ZLTT o Ensure that all employees involved in the operation of this

Pagina 12

08/04 VESTIL MFG. CO./T&S EQPT. CO. 5 of 16 ROUTINE MAINTENANCE & SAFETY CHECKS – ZLTT o Warning: Care should be taken to identify all pote

Pagina 13

08/04 VESTIL MFG. CO./T&S EQPT. CO. 6 of 16 EXPLODED PARTS VIEW AND BILL OF MATERIALS -- MODEL ZLTT

Pagina 14

08/04 VESTIL MFG. CO./T&S EQPT. CO. 7 of 16 BILL OF MATERIALS -- MODEL ZLTT

Pagina 15

08/04 VESTIL MFG. CO./T&S EQPT. CO. 8 of 16 MOTOR & TRANSFORMER CONNECTION DIAGRAMS CAUTION! If the motor voltage is changed, the wire on

Pagina 16 - POWERED PRODUCTS’ WARRANTY

08/04 VESTIL MFG. CO./T&S EQPT. CO. 9 of 16 ELECTRIC / HYDRAULIC BOM -- MODEL ZLTT Item #: Qty.: Part number: Part description: Electric

Commenti su questo manuale

Nessun commento

Vestil ZLTT series Manuale Utente

Navigare online o scaricare Manuale Utente per Apparecchiature Vestil ZLTT series. Vestil ZLTT series User Manual Manuale Utente

Sommario

Commenti su questo manuale

Prodotti e manuali riguardandi Apparecchiature Vestil ZLTT series